How To Put Up Curtain Rods

Similar to stick on curtain rods Command hooks are another answer to how to hang curtains without drilling into the wall. Align the bracket over the center of the 15â mark referenced in step 2 and use a pencil to mark the holes where the screws will go.

How To Hang Curtain Rods How Tos Diy

Depending on how large your window is youll need repeat all of the above steps for one or two more brackets.

How to put up curtain rods. Remove the cornice and install curtain rods for a fully mobile setup. Most curtain rods come with brackets that must be fastened to the wall so the rod can sit in them. In fact they even make some specifically for this purpose.

Mark a location for your curtain rod 4 in 10 cm above the window frame. Then measure for the curtain rods and drill into the wall at the appropriate spots. Place the rod into the right side bracket and use a level to determine the placement of the left side bracket.

Use a screwdriver to remove the cornice and its hardware from the wall. Measure the distance between the mounting brackets on the curtain rod youre installing and make another mark on. Tension the line enough so that the line supports much of the weight of the curtains.

DIY Curtain Rod. Put the curtains onto the curtain rod. Draw the curtains and let them sit for 1 hour to make sure the adhesive hooks can hold the weight.

Otherwise attach the panels to the rod with curtain rings or clips. Then set the rod into the brackets to hang the curtains. One simple and stealthy design.

If using rings put them in place on the rod now. Measure up 4 inches 10 cm and out 1 to 3 inches 25 to 76 mm on each side to find where your brackets should be placed and mark it with a pencil. Install a bracket or hook above the center of the rod on the wall or on the ceiling and connect it to the rod.

All you need to do is hang a hook on either side of the window and pop a rod it and youre done. Push the rod through your curtain if the curtain has eye-holes. These rods are installed by inserting one end of the rod while lowering the other end into the open bracket.

Make a mark with a pencil to denote one end of the curtain rod. String your curtain on the curtain rod and hang it up. Recruiting For Roman Polish German traditional corporate interior decorators.

Ad Apply for jobs across top companies locations. Use a rubber mallet to tap in the drywall anchors. If one of your brackets has an opening at the top make sure that its facing up.

Run the curtain rod through the hoops at the top of your curtains and then hang it up again. Use a small eye screw in the ceiling and use fish line to tie the rod to the screw for a decent solution that is. Curtain rods arent heavy enough to require extra support.

Youll need to get the curtain on the rod before you hang it unless youre using rings. Place curtains on the rod. You do not need to install the mounting brackets into a stud.

If your curtains have large eye-holes thread the rod through the openings. Unlock the curtain rod ends and get a friend to help you extend both sides of the rod. At this point youll want to put the curtains on the rod and then attach the finials before you put the rod up.

How To Install Curtain Rods 11 Steps With Pictures Wikihow